Correct installation, using and maintaining planetary deceleration is an important part of ensuring the normal operation of machinery and equipment.
2022-10-27 18:25:30Zhejiang Dongzheng Motor
Correct installation, using and maintaining planetary deceleration is an
important part of ensuring the normal operation of machinery and equipment.
Therefore, when installing the planet reducer, be sure to strictly assemble and
use it in strict accordance with the relevant matters below.
Step 1
Before installation, confirm whether the motor and the reducer are intact,
and strictly check whether the size of each part of the motor and the reducer is
matched. This is the size and tolerance of the motor's positioning of the
module, the input shaft and the groove of the reducer.
Step 2
Rotate the screws on the outer dust holes of France of France, adjust the PCS
system to clamp the ring to align the side holes with the dust holes, and insert
the inner hexagonal and spin. After that, take the motor axis key.
Step 3
Connect the motor to the reducer naturally. When connecting, it is necessary
to ensure that the overturn output shaft is consistent with the concentricity of
the motor input shaft, and the outside flange of the two is parallel. As the
heart is inconsistent, the motor shaft is broken or the gear is worn by the gear
of the motor.
In addition, when installation, it is strictly forbidden to use hammer and
other hits to prevent the axial or radial force from excessive damage to the
bearing or gear. Be sure to tighten the installation bolt and then spin the
tightly bolt. Before installation, wipe the motor input shaft, positioning
convex and reducer's gasoline or zinc sodium water in the connection part of the
motor. The purpose is to ensure the tightness of the connection and the
flexibility of operation, and to prevent unnecessary wear.
Before the motor is connected to the reducer, the motor shaft key slot should
be perpendicular to the tight bolt. In order to ensure uniform force, first spin
the installation bolt in any diagonal position, but do not spin, and then rotate
the installation bolts of the other two diagonal positions. Finally, tighten the
four installation bolts one by one. Finally, tightly tightly bolts. All tight
bolts need to be fixed and checked according to the indicated fixed torque
torque data.
The correct installation of the correct installation of the decelerator and
the mechanical equipment is the correct installation between the slowing machine
and the driver motor. The key is to ensure that the output shaft of the reducer
is consistent with the concentricity of the driving part.
choose an area code
分享到微信
×
Cookies
Cookies help us serve you better. By using this site, you agree to use cookies.We will not store any of your personal information.